Balancing toy Step by step

STEP 1 OF 2 THE BALANCE.

Step 1 - Get your 50 mm wide and 5 mm thick Steel bar then get a ruler and engineer square to mark out 80 mm on your bar.

Step 2 - Once you have marked out 80 mm, get your hack saw and cut along the line if you don't think your very good at cutting, give yourself up to 5 mm to cut along.

Step 3 - When you have finished Step 2 get your file and emery cloth, then proceed to clean the sides, the top and the bottom until shiny .

Step 4 -    Put engineer Blue on one side of your work to put in the markings of your shape for the toy.

Step 5 - Draw your shape and cut out your ideal drawing put it up against your work and Scribe in the out line using your scribe

Step 6 - Use the Band saw to cut out your markings that you put in with your scribe.

Step 7 - File all sides till smooth and file off the engineers blue.

After that you have finished The Balance.
------------------------------------------------------------------------------------------------------------
STEP 2 OF 2 THE BASE.

Step 1 - get your 20 mm wide and 5 mm thick steel and repeat step 1 from The balance but cut 100 mm instead

Step 2 - Proceed to to clean up your work until shiny like the balance.

Step 3 - Put Engineer blue on one side and mark out 10 mm and 20 mm on both ends, to find where to drill the holes.

Step 4 - Once marked out, Drill with the high speed 6 mm drill the holes in your markings.

Step 5 - Make the fittings for your bars.

Step 6  - Cut your steel bars in two and put in the holes

Step 7 - then proceed to weld the bars in the hole

Step 8 -